Let’s go over a few guidelines and steps to install your screen protector properly.
STEP 1.) You will need to put your Screen in ‘Screen Cleaning Mode’ before beginning. This should be in display settings.
STEP 2.) Use the cleaning kit provided with your Screen Protector’s packaging to clean off the dust on the screen. This is ESSENTIAL to do so that no dust gets trapped underneath the screen protector before you put it on. Start with the alcohol wipe cloth, followed by dry wipe and clear off any dust. Then, use the dust trap sticker in the cleaning kit to trap little particles of dust and make the screen spotless.
STEP 3.) Align the screen protector with the top edge of the screen and use guide stickers to temporarily tape it into position.
STEP 4.) Once the screen protector is correctly aligned and taped into position, Start peeling off the film from the back of the screen protector. Slowly pushing the screen protector back in place and assuring the curves align up perfectly.
STEP 5.) Push out air bubbles (if any) to the edges and peel off the guide stickers from the top of the screen.
STEP 6.) You are all done. Exit out of screen cleaning mode.